If the zone lights are all lit come back to me. 8 9713 0 910 Wait 10 seconds Press Exit Press exit Press exit Now try arming with 1234 if keypad is back to ready and power lights on. Function Code: Either a four (4) or six (6) digit code that has been programmed by the installer to operate a device. From here we will have to default the panel. Arm / Disarm Codes The NX-6 can have 40 four-digit or six- digit codes to ar m/disarm the control. The NetworX NX6 can handle up to 16 zones with 6 onboard and the rest can be had with zone expanders or wireless. That install code should be arming the alarm. NetworX Series NX-6 CONTROL PANEL Installation and Startup. It prevents confusion, and it's a good idea to keep that trick as an "ace in the hole" because one _can_ delete or scramble the master code, while trying to set or change user codes if you lose track of what you are doing. The NetworX NX4 can handle up to 8 zones with 4 onboard and up to 8 user codes. Once you are sure the master code works, go back into programming and repeat the sequence to disable the installer code as a master code. *5 (ready light will flash)Įnter "01" (the master code is User code 01) Jason of Alarm System Store walks you through a DIY tutorial on how to add, change, and remove user codes on the Interlogix NetworX NX4, NX6, and NX8 alarm s. Give it a minute to settle after exiting programming format, call Alarm Lock customer service (have your. Press * a second time (accepting the data in the next segment that you are making no changes to) strike) when a proper user code or proximity credential is presented. Its NOT the wiring, resistors or contacts - have switched all (.
Press * (it's essentially the "enter" key I have a NX-6 board monitoring my home, I have doubled the zones.
Press "4" to turn on option 4 (this lets the installer code act as a master user code) Ok! What we are going to do is temporarily set the installer code to act as a master code (a trick that only works if you are already disarmed).
0 kommentar(er)
